Back to Support

How do I change the IP address of the Camera?

There are 2 ways of changing the IP address of the camera.
 

 Through the Camera Settings

1.       Access the home page of the camera you wish to modify.

2.       Click on settings

3.       Enter the user name “admin” and the password for this camera.

         

4.       You should now see a new window that enables you to change the setting of your camera.

          Click on Network and then on TCP/IP Setup

         

5.       Click on “Use the following IP address” and change the IP address. You may also wish to verify the Subnet Mask, default Gateway and Primary and Secondary DNS server address.  These setting can be found by accessing your router homepage.

6.       Click “Apply” to save your settings. You may need to re-login to your camera using the new IP address in order to view the camera or make further changes.

Through the camera setup utility

1.       Launch the camera setup software and locate your camera from the list (click Refresh if necessary)

2.       Click once on the camera you wish to modify then click Setup

3.       Enter the user name “admin” and the password  for this camera.

         

4.       You should now see a new window that enables you to change the IP address.

         

5.       Click on “Use the following IP address” and change the IP address. You may also wish to verify the Subnet Mask, default Gateway and Primary and Secondary DNS server address. These setting can be found by accessing your router homepage. 

6.       Click “Apply” then after the message “Configuration Accepted” click “Ok” then “Exit”

 

Back to support